How to Build Teak Bath Mat

May 20th

Teak wood has a fine grain that is naturally resistant to mold and bacteria. This makes it an ideal material for create a teak bath mat. This wooden bridge gives your bathroom a natural light thin, allow water to drain down, minimizing the dirt on the top surface.

Roll Up Teak Bath Mat
Roll Up Teak Bath Mat

To build teak bath mat, size 36 inches long stretches of teak slats and draw a line on a signal to indicate a cut. Create 12 sections that are 36 inches long and 3 sections measuring 24 cm in length. Sand the surfaces until the wood is smooth.

11 Photos Gallery of: How to Build Teak Bath Mat

Image of: Great Teak Bath Mat
Image of: Simple Teak Bath Mat
Image of: Classic Teak Bath Mat
Image of: Similar Teak Bath Mat
Image of: Solid Teak Bath Mat
Image of: Teak Bath Mat Image
Image of: Teak Bath Mat Picture
Image of: Beautiful Teak Bath Mat
Image of: Teak Bath Mat Photos
Image of: Image of Teak Bath Mat
Image of: Roll Up Teak Bath Mat
 

Place the 12 long sections of wood on the work surface with flat ends opposite the large table and the minor sides touching. Place small rows vertically above 12 long pieces, placing it at the center of the block. Insert a brass screw into each hole and tighten.

Put each of the other two shorter pieces of teak vertically on top of the box. Put about 6 cm from the right edge and the other 6 cm from the left margin. Finally, to build teak bath mat, connect four adhesive rubber pads of the foot cell at the corners of the bottom of the pad.

Best Post |  Freestanding Bathtub Design